American-fibertek MT-1 Bedienungsanleitung PDF herunterladen (Seite 3)

INSTALLATION

THIS INSTALLATION SHOULD BE MADE BY A QUALIFIED SERVICE PERSON AND

SHOULD CONFORM TO THE NATIONAL ELECTRICAL CODE, ANSI/NFPA 70 AND

LOCAL CODES.

Mount the unit directly to the output of a video source. Be sure to allow sufficient room

for the required minimum bend radius of the fiber cable used.

POWER SOURCE

THIS PRODUCT SHALL BE POWERED BY A LISTED CLASS 2 POWER SUPPLY

ONLY.

This unit requires a +12VDC power source for proper operation. Current draw is

approximately 50mA maximum. In the USA and in Canada an American Fibertek PS-12

is supplied with this unit. The negative side of the power input is directly connected to

ground. ANSI/NFPA 70 Class 2 wiring is recommended.

POWER CONNECTION

Power is supplied to the unit via a two wire copper cable. The red wire is connected to

+12 volt dc and the black wire is connected to ground.

FIBER CONNECTION

The fiber optic connection is made via a ST connector located on the side of the unit.

VIDEO INPUT CONNECTION

The video input connection is made via a BNC connector on the side of the unit. The

video input should be directly connected to an appropriate 75Ω baseband video source

such as the output of a camera.

1 2 3 4

Keine Kommentare

American-fibertek MT-1 Bedienungsanleitung Seite 3